Car engine-How to clean your car engine
Car engine-How to clean your car engine
Knowing how to clean a car engine is an important part of the process of maintaining it, and it enables you to save money, and cleaning equipment under the hood helps extend the life of belts, hoses and other parts, in addition to making it easier to detect leaks, drips or any type of damage on a clean engine, know the steps The following is on how to properly clean your car’s engine, and be sure to check your car’s operating manual before starting.
1- Remove any residue or sediment from car engine
The hood, grille, and air vents are the most common areas of dirt buildup, clean with a compressor or clean the areas with a manual wire brush.
2- Adjust the temperature
Next, let the engine warm up to a moderate temperature – not too hot, and the heat will help loosen and melt the grease that has built up in the engine compartment.
3- Know what to cover when cleaning the engine
Use plastic food bags to cover some parts when it’s time to clean your car. Those parts that should be covered when cleaning the engine are:
- Electrical wires
- Sensors
- Spark plug holes
- Born
Spark diffuser, then secure the bags with tape, and to protect the battery, cover or simply peel them off.
4- Don’t forget the drip pan
Place old towels or a mat under the motor oil drip pan to absorb any harmful residue.
5- Spray the engine with cleaning fluid
Spray the entire engine compartment with engine cleaner. Avoid spraying wires you have covered and glued. Petroleum-based cleaners can damage rubber and vinyl parts. You can use citrus-based cleaners to remove grease. Leave the cleaner for 15-30 minutes on the parts that build up. Oil and grease in abundance, and repeat the use of the cleaner if necessary.
6- Rinse and remove bags
After the engine cleaner does its turn, rinse the engine and other parts with water, then remove the bags you used to protect the wires. Once the towel or mat is dry, dispose of it properly. If you removed the battery, don’t forget to install it again.
7- Remove excess moisture
Empty the excess water into the engine compartment using an air compressor.
8- Dry the internal parts
Finally, start your car’s engine and let it run until it’s hot, the heat will help dry out the hard-to-reach interior parts.
Now that you know how to clean and take care of your car engine, you can experiment on your own, as the maintenance process maintains the life and quality of your car, but remember that protecting your car is not only limited to regular inspections and cleaning schedules, try to learn also how car insurance to keep you safe And the safety of your car on the road.